Unpacking And Testing The Appliance; Locating The Fireplace - Stanley Argon NMARWH90 Manual

UNPACKING AND TESTING APPLIANCE
Carefully remove the appliance from the box. Prior to installing the appliance, test to make
sure the appliance operates properly by plugging the power supply cord into a conveniently
located 240 Volt grounded outlet.
There are two screws on each side to fix the front glass.
Please see the figure right side.
TAKE OUT THIS SCREW ON EACH SIDE
before you take off the front glass.
As with most electronic devices, your new electric fireplace has been designed to operate at
temperatures between 5
fireplace to reach room temperature before turning it on.
NOTE: There may be trace of odor during the first few minutes of initial use. This is
harmless, normal and will never occur again.

LOCATING THE FIREPLACE

Plan where to locate and frame the fireplace. This will save time and money later when you
install the fireplace. Before installation consider the following:
1. Where the fireplace is located must allow for wall and ceiling clearances (see
INSTALLATION-WALL MOUNT)
2. Consider a location where the fireplace screen will not be exposed to direct sunlight from
windows or doors.
A 15 ampere, 240 Volt, 50 Hz branch circuit with proper ground must be available at the
3.
location. Preferably a dedicated branch circuit should be provided to avoid circuit
breakers to trip of fuses to blow.
℃ (41℉) and 35 ℃ (95℉). During the cold winter months, allow the
4
Screw