Installation - Stanley Argon Cube Manual

INSTALLATION WALL-MOUNT
NOTE: Due to the many different materials used on different walls, it is highly recommended NOTE: Due to the many different materials used on different walls, it is highly recommended NOTE: Due to the many different materials used on different walls, it is highly recommended
that you consult your local builder before you install this appliance. that you consult your local builder before you install this appliance.
1. Select a location that is not prone to Select a location that is not prone to
moisture and is located at least 0.91 m or 3 moisture and is located at least 0.91 m or 3
feet away from combustible materials such from combustible materials such
as curtains or drapes, furniture, bedding, as curtains or drapes, furniture, bedding,
paper, etc.
2. Select a suitable position in whic elect a suitable position in which to mount
the heater horizontally – use a spirit level to
achieve this (Fig. 1).
3. Check the wall to ensure there is no wiring, Check the wall to ensure there is no wiring,
pipe wires etc. in the area to be drilled. Drill in the area to be drilled. Drill
8 or more pilot holes (8mm diameter &
40mm depth) using a suitable size drill and 40mm depth) using a suitable size drill a
put the wall plugs into the holes.
4. Take out the hanger from the fireplace by out the hanger from the fireplace by
unscrew the screw (Fig.2).
5. Fix the hanger to the
6. Avoid fireplace to move, use screw fix fireplace to move, use screw fix
fireplace to wall (Fig. 4).
Warning!
Be sure that the bolts have been fixed
firmly enough to withstand the weight firmly enough to withstand the weight！
MOUNT
use a spirit level to
holes (8mm diameter &
holes.
wall. Referring to Fig. 3 Referring to Fig. 3.
have been fixed
Fig. 1
6
Fig. 2 Fig. 2
Fig.3 Fig.3
Fig. 4 Fig. 4