Unpacking And Testing The Appliance; Locating The Fireplace - Stanley NMARBI100 Manual

UNPACKING AND TESTING APPLIANCE
Carefully remove the appliance from the box. Prior to installing the appliance, test to make sure the
appliance operates properly by plugging the power supply cord into a conveniently located 240 Volt
grounded outlet.

LOCATING THE FIREPLACE

Plan where to locate and frame the fireplace. This will save time and money later when you install
the fireplace. Before installation consider the following:
1. Where the fireplace is located must allow for wall and ceiling clearances (see INSTALLATION)
2. Consider a location where the fireplace screen will not be exposed to direct sunlight from
windows or doors.
A 15 ampere, 240 Volt, 50 Hz branch circuit with proper ground must be available at the location.
3.
Preferably a dedicated branch circuit should be provided to avoid circuit breakers to trip of fuses
to blow.
4