Trouble Shooting - Stanley Argon Built 3 Sided Manual

TROUBLE SHOOTING

PROBLEM
Dim or no flame
Ember bed is not
glowing or dimming
Appliance turns off and
will not turn on
Appliance will not come
on when switch
flipped to ON
No warm air coming out
of appliance
Flame sputters
Remote Control does
not work.
Flame is fixed.
POSSIBLE CAUSE
Flame LED's are burnt out
Ember LED's are burnt out
Appliance has overheated and
safety device has caused the
thermal switch to disconnect
House circuit
tripped
Appliance's fuse has blown
Appliance is not plugged into an
is electrical outlet
Appliance has overheated and
safety device has caused the
thermal switch to disconnect
Circuit board is burnt out
Heater is burnt out
Flame motor is defective.
Low batteries.
Unit switch in "O" position.
Wiring may be loose or the
flame motor may be defective.
SOLUTION
Inspect the LED's and replace them if
necessary.
Inspect the ember bed LED's and
replace them if necessary.
Turn off the main switch, allow
appliance to cool for 10 minutes, then
turn it on.
breaker has Reset house circuit breaker.
Replace the fuse.
Check plug and plug in.
Turn off the main switch, allow
appliance to cool for 10 minutes, then
turn it on.
Inspect the circuit board and replace
it if necessary.
Inspect
assembly and replace it if necessary.
Call a qualified service technician and
replace flame motor.
Replace AAA batteries in remote
control.
Turn the switch in "I" position.
24
the burner and heater