Safety Instructions - Ape Labs Mobilight User Manual

ape labs mobilight user manual

SAFETY INSTRUCTIONS

This device has left our premises in absolutely perfect condition. In order
to maintain this condition and to ensure a safe operation, it is absolutely
necessary for the user to follow the safety instructions and warning
notes written in this user manual.
Damages caused by the disregard of this user manual are not subject to war-
ranty. The dealer will not accept liability for any resulting defects or problems.
If the device has been exposed to drastic temperature fluctuation (e.g. after
transportation), do not switch it on immediately. The arising condensation
water might damage your device. Leave the device switched off until it has
reached room temperature.
Should you notice any damages on the A/C connection cable or on the casing,
do not take the device into operation and immediately consult your local dealer.
This device falls under protection-class III. The power plug must only be
plugged into a protection class III utlet. The voltage and frequency must ex-
actly be the same as stated on the device. Wrong voltages or power outlets
can lead to the destruction of the device and to mortal electrical shock.
Always plug in the power plug last. The power plug must always be inserted
without force. Make sure that the plug is tightly connected with the outlet.
Never let the power-cord come into contact with other cables! Handle the
power-cord and all connections.
Never modify, bend, strain mechanically, put pressure on, pull or heat up
the power cord. Never operate next to sources of heat or cold. Disregard
can lead to power cord damages, fire or mortal electrical shock.
The cable insert or the female part in the device must never be strained.
There must always be sufficient cable to the device. Otherwise, the cable
may be damaged which may lead to mortal damage.
Make sure that the power-cord is never crimped or damaged by sharp
edges. Check the device and the power-cord from time to time.
If extension cords are used, make sure that the core diameter is sufficient
for the required power consumption of the device. All warnings concerning
the power cords are also valid for possible extension cords.
Always disconnect from the mains, when the device is not in use or before
cleaning it. Only handle the power-cord by the plug. Never pull out the plug
by tugging the power-cord. Otherwise, the cable or plug can be damaged
leading to mortal electrical shock. If the power plug or the power switch is
not accessible, the device must be disconnected via the mains.
15