Specifications - Makita DCS551 Instruction Manual

ENGLISH (Original instructions)
1. Button
2. Red indicator
3. Battery cartridge
4. Indicator lamps
5. Check button
6. Switch trigger
7. Lock-off lever
8. Battery indicator
9. Mode indicator
10. Lever

SPECIFICATIONS

Blade diameter
Max. Cutting depth
No load speed
Overall length (with BL1830)
Rated voltage
• Due to our continuing program of research and development, the specifications herein are subject to change without
notice.
• Specifications and battery cartridge may differ from country to country.
• Weight, with battery cartridge, according to EPTA-Procedure 01/2003
Symbols
The following show the symbols used for the equipment.
Be sure that you understand their meaning before use.
...... Read instruction manual.
Intended use
The tool is intended for cutting in mild steel.
General Power Tool Safety
Warnings
WARNING Read all safety warnings and all
instructions. Failure to follow the warnings and
instructions may result in electric shock, fire and/or
serious injury.
Save all warnings and
instructions for future reference.
The term "power tool" in the warnings refers to your
mains-operated (corded) power tool or battery-operated
(cordless) power tool.
Work area safety
1. Keep work area clean and well lit. Cluttered or dark
areas invite accidents.
2. Do not operate power tools in explosive
atmospheres, such as in the presence of
flammable liquids, gases or dust. Power tools
create sparks which may ignite the dust or fumes.
4
Explanation of general view
11. Alignment line
12. Cutting line
13. Base
14. Lamp
15. Shaft lock
16. Hex wrench
17. Hex bolt
18. Outer flange
19. Saw blade
20. Inner flange
Model
Net weight
END004-6
3. Keep children and bystanders away while
operating a power tool. Distractions can cause you
to lose control.
Electrical safety
4. Power tool plugs must match the outlet. Never
modify the plug in any way. Do not use any
ENE022-1
adapter plugs with earthed (grounded) power
tools. Unmodified plugs and matching outlets will
reduce risk of electric shock.
5. Avoid body contact with earthed or grounded
GEA006-2
surfaces such as pipes, radiators, ranges and
refrigerators. There is an increased risk of electric
shock if your body is earthed or grounded.
6. Do not expose power tools to rain or wet
conditions. Water entering a power tool will increase
the risk of electric shock.
7. Do not abuse the cord. Never use the cord for
carrying, pulling or unplugging the power tool.
Keep cord away from heat, oil, sharp edges or
moving parts. Damaged or entangled cords increase
the risk of electric shock.
8. When operating a power tool outdoors, use an
extension cord suitable for outdoor use. Use of a
cord suitable for outdoor use reduces the risk of
electric shock.
9. If operating a power tool in a damp location is
unavoidable, use a ground fault circuit interrupter
(GFCI) protected supply. Use of an GFCI reduces
the risk of electric shock.
21. Cup washer
22. Hook
23. Screw
24. Front grip
25. Rear handle
26. Sight grooves
27. Clamp screw
28. Rip fence (Guide rule)
DCS551
136 mm - 150 mm
57.5 mm (with 150 mm diameter)
-1
3,900 min
332 mm
D.C. 18V
2.9 kg