Move The Load; Lowering A Load; Care, Maintenance And Overhaul; Care By Cleaning - unicraft EKZT Series Operating Instructions Manual

Care, maintenance and overhaul

7.5 Move the load

ATTENTION!
- Ensure that there are no obstacles in the path of
the load.
- Do not allow the load to swing.
Step 1: Raise the load only to the point where it can be
moved easily over the distance it needs to travel.
Step 2: Move the button to the "Right" or "Left" position
and move the load slowly and steadily in one di-
rection.

7.6 Lowering a load

Step 1: Press the button "DOWN".
Step 2: Lower the load gently and evenly.
ATTENTION!
crushing!
There is a danger of upper and lower limbs being
crushed when the load is set down.
- Do not allow upper or lower limbs to come between
the load and the floor when it is being set down.
Step 3: Place the load on a firm, safe surface.
Step 4: Open the latch of the load hook and disconnect
the load.
8 Care, maintenance and overhaul
WARNING!
Danger of injury due to the use of
wrong spare parts!
The use of incorrect or faulty replacement parts can result
in danger to personnel and damage and malfunction.
- Only use original spare parts from the manufacturer or
replacement parts approved by the manufacturer.
- If you have any questions, always contact the manu-
facturer.
NOTE!
Loss of warranty
- Using non-approved spare parts voids the manu-
facturer's warranty.
12

8.1 Care by cleaning

The electric chain hoist must always be kept clean.
Use protective gloves!
NOTE!
Never use strong cleaning agents for any cleaning ta-
sks. This may damage or destroy the device.
All plastic and lacquered surfaces should be cleaned
using a soft, damp cloth and a neutral cleaning agent.
Remove any excess lubricant or leaked oil using a dry,
lint-free cloth.

8.2 Inspection, maintenance and repair

Daily check of chain hoist
Step 1: Check the chain links, the hooks and the hook
retainers for wear and external damage before
each use.
Step 2: Check the chain hoist for external damage and
for completeness and tightness of all bolts and
nuts before each use.

8.3 Maintenance Schedule

ATTENTION!
Maintenance and repair work may only be carried out
by qualified personnel.
If increased wear is detected during regular checks,
shorten the required maintenance intervals according to
the actual signs of wear. If you have questions about
maintenance work and intervals, contact the manufactu-
rer. The contact details can be found in chapter 1.2 Cu-
stomer Service.
If the electric chain hoist does not work properly, contact
a dealer or our customer service. The contact details can
be found in chapter 1.2 Customer Service.
All protection and safety equipment must be reinstalled
immediately after completion of repair and maintenance
work.
EKZT-Series | Version 1.04