Troubleshooting; Disposal, Recycling Of Used Devices; Decommissioning; Disposal Of Lubricants - unicraft EKZT Series Operating Instructions Manual

10 Troubleshooting

Faults
Chain hoist motor is not functioning.
Motor restarts after function key is re-
leased.
Temperature of motor too high
Runs on too long after switch-off.
Unusual noises.
Upper and lower limit switches not
functioning.
Leakage current

11 Disposal, recycling of used devices

Please take care in your own interest and in the interest
of the environment that all component parts of the ma-
chine are only disposed of in the intended and permitted
way.

11.1 Decommissioning

Immediately decommission used machines in order to
avoid later misuse and endangering of the envi-ronment
or of persons.
Step 1: Eliminate all environmentally hazardous ope-
rat-ing materials from the used device.
Step 2: If required, disassemble the machine into easy-
to-handle and usable components and parts.
Step 3: Dispose of machine components and operating
materials by the disposal channels provided.
EKZT-Series | Version 1.04
Possible cause
1. Inadequate power supply
2. Wrong phase conductor
3. Switch defective
4. Rectifier defective
5. Transformer defective
6. Motor defective
Switch defective
Workload too great
1. Oily brake disc
2. Worn brake disc
3. Compression spring defective
4. Overload
1. .Chain dry or very worn
2. Gear wheels very worn
1. Poor connection
2. Limit switch defective
1. Poor or no earthing
2. Interior cables are in contact with
the casing
3. Humidity too high
4. Live components dirty

11.2 Disposal of lubricants

Remove any leaking, used or excessive grease at the lu-
bricating points.
Disposal notes for used lubricants are available from the
manufacturer of the lubricants. If necessary, request the
productspecific data sheets.
Troubleshooting
Solution
1. Check power supply
2. Change phase
3. Replace switch
4. Replace rectifier
5. Replace transformer
6. Change motor
Replace switch
Reduce load
1. Clean the brake disc.
2. Replace the brake disc.
3. Replace the compression spring.
4. Reduce load.
1. Lubricate or replace chain
2. Replace gear wheels
1. Check connection
2. Replace limit switch
1. Check earthing or make connec-
tion.
2. Check cables.
3. Avoid working when the humidity
is too high.
4. Keep the appliance parts clean.
15