Removing A Drive Blank - Cisco UCS X10c Installation And Service Manual

Removing a Drive Blank

Removing a Drive Blank
A maximum of U.2 NVMe drives are contained in the front mezzanine storage module. If your front mezzanine
module has fewer than two U.2 drives, you must install drive blank panels in the empty drive bays.
Note
Use this procedure to remove a drive blank.
Step 1 Grasp the drive blank handle.
Step 2 Slide the drive blank out of the slot.
Cisco UCS X10c Front Mezzanine GPU Module Installation and Service Guide
24
Do not operate a front mezzanine GPU module that has empty drive bays without a drive blank panel.
Servicing the GPU Module