Start-Up Procedure For Your Pool - Intec CA10 Instruction Manual

4. START-UP PROCEDURE FOR YOUR POOL

Start-up of Pool
This order of instructions should be followed precisely to properly ionize your pool. If you
are converting from chlorine, salt water generated, or other sanitation method, there is no
need to drain your pool.
1. Clean out all debris and clean out skimmers (Please see Section 9.0 if applicable)
2. Adjust pH between 7.0 – 7.4
3. Run the Ionizer continuously until the copper level reaches 0.5 ppm.
REMEMBER: Your pool pump must be running and water must be flowing
over the copper bars when the Ionizer is on.
4. Treat water clarity
5. Treat Calcium Hardness
Initial Start-up for the CA10 or CV50
These unit are equipped with a potentiometer to control the copper output. Turn the
dial counterclockwise to the lowest setting, and turn the unit on with water flowing through
the copper electrode chamber. As the water is flowing through, turn the dial clockwise
until it is on full power. If the power light flashes/blinks sporadically, turn the knob
again counterclockwise until the power light is solid and not flashing. This is the
maximum output for your pool water conductivity.
Initial Start-up for the CV60
Similar to the above. However, this unit is equipped with push buttons to control the
copper output. Turn the unit on with water flowing through the copper electrode chamber.
As the water is flowing through, pay attention to the LED lights to the right of the display.
If the any light flashes/blinks sporadically, push the down arrow one click at a time
until the power light is solid and not flashing. This is the maximum output for your pool
water conductivity.
20