Intec CA10 Instruction Manual page 13

Male
Union
2" Plumbing
Use a hacksaw and cut approximately 11.5 inches out of the pipe after the filter
The electrode can be installed horizontally or vertically. Take the male half of each union
and clean and cement them on the remaining pipe ends. Slide in the electrode and hand
tighten the female union to the male union.
Connecting the Electronic Controller to the Flow Switch
There are 4 wire connections coming from the CV60 terminal. Please note, the
red female plugs of the
switch as shown
Connecting the Electronic Controller to the Copper Electrode
Locate the
the blue female plug
side of the electrode (Figure
to the other side of the electrode (Figure 5).
which side of the electrode.
copper bars on the
electronics unit to
Bushing
Reducer
Figure 6
electronics system will
below (Figure 6).
male spades found at each side of
from the CV60
7). Attach
The polarity
electrode. Figure 8
the electrode.
plug into the red male plugs of the flow
the
electronics unit to the male spade located on the
the unconnected
It does not matter which wire plugs into
will alternate
illustrates the proper
13
Assembly
Component
Figure 7
electrode (Figure 7). Connect
wire for the electronics
the current between the two
connection for
Female
Union
unit
the