Table of Contents
Advertisement
Please note the arrow
through the filter, into the electrode or flow cell.
flows in the direction of the arrow or
shows
the entire
to
your
CV60
electronics system.
Installation of the Electrode
1.5" Plumbing
You will need to use a 2" to 1.5" reducer bushing (not provided). The electrode
can be installed horizontally or vertically. Take the male half of each male union, clean
them both, and then cement the bushing/reducer into the male union on the electrode
(Figure 6).
Use a hacksaw and cut approximately 12 inches out of the pipe after the filter.
Please note – this measurement can be different as bushings vary in depth. Take the male
half of each union that contains the reducer/bushing, clean the inside and cement assembly
component on the remaining pipe ends (Figure 7). Slide in the electrode and hand tighten
the female union to the male union.
shown
electrode
with the lead wires from the flow switch that will connect
Figure 4
in
Figure
4
below. The water flows
your
system will not produce
12
Ensure
the
water
Figure 5
from the pump,
leaving the
cell
copper. Figure 5
Advertisement
Table of Contents
