Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for NI sbRIO-9697
Summary of Contents for NI sbRIO-9697
- Page 1 Getting Started 2022-07-06...
-
Page 2: Table Of Contents
Installing the NI 9697........ -
Page 3: Installation Purpose (Rio Mezzanine Card)
Getting Started Installation Purpose (RIO Mezzanine Card) The NI 9697 two-slot C Series RIO Mezzanine Card is an accessory you can use to connect up to two board-only C Series modules to the NI sbRIO-9607/9627. sbRIO RMC Interface Connector... - Page 4 NI makes no electromagnetic compatibility (EMC) or CE marking compliance claims for the NI 9697. The end-product supplier is responsible for conformity to any and all compliance requirements. Caution The NI 9697 must be installed inside a suitable enclosure prior to use. Hazardous voltages may be present. ni.com...
-
Page 5: Digital I/O Connector Pinouts
The protection provided by the NI 9697 can be impaired if the NI 9697 is used in a manner not described in this document. Digital I/O Connector Pinouts The following figure shows the pinouts of the I/O connector on the NI sbRIO device. Figure 2. Pinout of the DIO Connector Pin 1... -
Page 6: Installing The Ni 9697
Screwdriver, Phillips #1 ■ Complete the following steps to install the NI 9697. 1. Attach the three C Series support brackets to the NI 9697 using six of the M3 × 4 mm black, low-profile screws included in the kit. Note Do not tighten the screws until you reach step 8. - Page 7 Figure 5. Inserting Three Screws into the Module and Bracket Holes 4. Insert the six M3 × 7 mm standoffs from the secondary side of the NI sbRIO device into the six mounting standoffs for your application. The mounting standoffs are not included in the NI 9697 kit.
- Page 8 6. Press the isolator sheet over the standoffs so that 1 mm to 2 mm of standoff protrudes through the holes. 7. Align the bracket holes attached to the NI 9697 with the tops of the M3 × 7 mm standoffs, and insert the six M3 × 7 mm silver low-profile screws.
- Page 9 3. Isolator 8. Tighten all the screws to 0.45 N · m (4.0 lb · in.). Do not overtighten. The following figures show the dimensions of the assembled NI 9697 and NI sbRIO device with two board-only C Series modules.
-
Page 10: Specifications
Specifications Refer to the documentation for the NI sbRIO device and the board-only C Series modules for the specifications of those products. 3.3 V Digital I/O on 50-Pin IDC Connector Number of DIO channels Maximum tested current per channel ±3 mA... -
Page 11: Physical Characteristics
Operating temperature (IEC 60068-2-1, IEC 60068-2-2) -40 °C to 85 °C Thermal validation of an NI sbRIO system assembled with the NI 9697 requires validating the NI sbRIO device and board-only C Series modules. Measure the operating temperature of board-only C Series modules 7.6 mm (0.3 in.) above the module surface. -
Page 12: Eu And Uk Customers
• Waste Electrical and Electronic Equipment (WEEE)—At the end of the product life cycle, all NI products must be disposed of according to local laws and regulations. For more information about how to recycle NI products in your region, visit ni.com/...
Need help?
Do you have a question about the sbRIO-9697 and is the answer not in the manual?
Questions and answers