Software Setup; Installing The Operating System; Upgrading Device Drivers - HP xw4000 Getting Started Manual

Linux-based workstations

Hide thumbs Also See for xw4000:

Table of Contents

getting started guide

CAUTION: Do not add optional hardware devices or third-party devices

to your computer until the operating system is successfully installed. Doing

so may cause errors and may prevent the operating system from installing

properly.

CAUTION: Once the automatic installation has begun, DO NOT TURN

OFF THE WORKSTATION UNTIL THE PROCESS IS COMPLETE. Turning off

the workstation during the installation process may damage the software

that runs the workstation or prevent its proper installation.

Your Linux workstation has pre-installed Red Hat® Linux and

HP software. It is initialized the first time you start the workstation.

This process takes a few minutes. The Linux Setup Tool utility

displays during the initialization process. The program allows you to

enter your password, network, graphics, time, and keyboard settings

for your workstation.

For more information about setting up your Linux operating system,

refer to Chapter 2, "Linux system setup and recovery" later in this

document.

To install optional hardware devices after the OS installation is

complete, you must install the device drivers for the devices you are

installing.

From the HP support site

can download the latest drivers and BIOS for your workstation.

software setup

www.hp.com/go/workstationsupport

, you

1–1

Table of Contents

Xw6000