Changing Boot/Network Parameters; Static Boot Protocol - HP xw4000 Getting Started Manual

Linux-based workstations
Hide thumbs Also See for xw4000:
Table of Contents

Advertisement

Linux system setup and recovery

changing boot/network parameters

static boot protocol

2–4
Choose the Network tab and the following window displays.
There are three kinds of booting protocols that setparms can set up for
you: Static, DHCP, and BOOTP. Choose the appropriate protocol
based on the following descriptions:
If you choose Static booting, you will have to set several networking
parameters. Some of these are described below.
You will also need to provide an IP address for your workstation, a
hostname, the IP address of the network gateway for your system, the
netmask (255.255.248.0 for example), and a network domain name
(for example, company_name.com).
Set up your DNS Configuration. Refer to the section "DNS
Parameters Configuration" in this chapter for an example of the
screen interface and instructions.
getting started guide

Advertisement

Table of Contents
loading

This manual is also suitable for:

Xw6000

Table of Contents