Siemens SIMATIC PN/CAN LINK Operating Instructions Manual page 26

2. If you want to use the firmware version V2.0, click "Change firmware version" and confirm
the message output by clicking "OK". The firmware version 2.0 is shown in the hardware
catalog. All nodes and OD entries are visible and work as intended.
NOTICE
You are not permitted to transfer nodes, process data, messages between V1.0 and V2.0
within devices.
To avoid inconsistencies and ensure correct configuration, you must update the module
description on all devices.
• Use the "Update module description" button if you want to use firmware version V1.0.
• Use the "Update module description" and "Change firmware version" buttons if you want
Figure 3-5 Update module description
Figure 3-6 Changing the firmware version
SIMATIC PN/CAN LINK
Operating Instructions, 03/2022, A5E39895388-AC
to use firmware version V2.0.
New properties/functions
3.3 Installation and handling of the new HSP
25