Unpacking The Server - HP rx5670 Hardware Installation Manual

Server Overview and Unpacking

Unpacking the Server

Unpacking the Server
Hewlett-Packard shipping containers protect their contents under normal shipping conditions. After the
equipment arrives, carefully inspect each carton for signs of shipping damage. A tilt indicator is installed on
each carton shipped. The beads in the indicator will roll to the upper position if the container has been tilted
to an angle that could cause equipment damage. The tilt indicator itself will have two windows and each
window under normal conditions will show four beads present. If a carton has been mishandled, accidentally
dropped, or knocked against something, the tilt indicator will indicate missing beads. If damage is found,
document the damage with photographs and contact the transport carrier immediately.
Examine the server cabinet for visible shipping damage. After unpacking the cabinet, check for damage that
may have been obscured by the shipping container. If damage is found after visual inspection, document the
damage with photographs and contact the transport carrier immediately.
If the equipment has any damage, a damage claim form must be obtained by the customer from the shipping
representative. The customer should complete the form and return it to the shipping representative.
The server may come already racked or ready for rack installation.
NOTE
Unpacking a Racked Server
This section contains information pertaining to unpacking the hp server rx5670 cabinet.
WARNING Wear protective glasses while cutting the plastic bands around the shipping
container. These bands are under tension. When cut, they can spring back and cause
serious eye injury.
NOTE Position the pallet to allow for enough space to roll the cabinet off the pallet before starting.
To remove the hp server rx5670 cabinet, perform the following steps:
1. Cut the polystrap bands around the shipping container.
12
Chapter 1