HP rx5670 Hardware Installation Manual page 27

4. Connect the Processor power cable (Figure 2-7, item 4).
5. Place the Processor Retention Cover (Figure 2-7, item 5) over the Processor.
NOTE When performing the following step, the screws should be tightened in sequence as shown
on the following graphic. Each screw should be turned 2-3 times until all screws are
bottomed out.
Figure 2-7 Processor Installation
1st
4
6. Tighten the captive T-15 screws to secure the Processor Retention Cover.
Replacing the Processor Extender Board
To replace the Processor Extender Board, perform the following steps:
1. Ensure the extraction levers are positioned in the outward, unlocked position.
2. Align the Processor Extender Board with the front and rear Card Guides.
3. Slide the Processor Extender Board down until it begins to seat in the socket located on the System
Baseboard.
4. Push the extraction levers inward to the locked position in order to fully seat the Processor Extender
Board.
Chapter 2
4th
3rd
1
Installing Processors and Memory
5
2nd
2 4x
Installing Additional Components
3
27