HP Visualize c160 Install Manual page 5

RavenC160-180.FB 3 Wed Jul 10 14:00:20 1996
WARNING:
CAUTION:
Figure 1
5 Unplug the power cord from the back of the system unit.
To avoid electrical shock, make sure you unplug the power cable from
the wall outlet and the system unit before proceeding any further.
The internal components of your workstation are susceptible to mechanical and
electrostatic shock. To prevent such damage from occurring, observe the following
precauxtions during the installation procedure.
•
Stand on a static-free mat
•
Wear a static-grounding wrist strap to ensure that any accumulated electrostatic charge
discharges from your body to ground. Attach the static-grounding wrist strap by fol-
lowing the instructions on the package that contains the strap. Be sure to attach one
end of the strap to the system chassis.
6 Disconnect all cables, connectors, and terminators from the connectors on the
front and rear of the system.
7 Remove the system unit from the floor stand, as shown in Figure 1.
Removing the Floor Stand
Preparing Your Workstation
3