To Adjust the Slide Rail
This procedure is required only if the positions of the front mounting brackets, the
locking brackets, or the slide have been changed from the factory condition.
1. Adjust the position of the rails.
a. Remove the tray from the slide rails as explained on page 18.
b. Loosen the 10 outer adjustment screws (
Some adjustment screws are not readily accessible. To access these screws, you
must extend or retract the slide until access holes on the slide line up with the
screws.
c. Push the slide rails all the way into the rack.
d. Tighten the outer adjustment screws.
Retma rail
FIGURE 2-8
22
Sun StorEdge L1000 User's Guide • May 1998
Inner adjustment screws (both sides)
FRONT
Outer adjustment screws (both sides)
Slide Assembly—Top View
).
FIGURE 2-8
TH00018a