Summary of Contents for Cuisinart Bristol SMK1021ASO
Page 1
Bristol 21” Pellet Grill OWNER’S MANUAL OPERATING IN STRUC TIONS SAVE THIS MANUAL FOR FUTURE REFERENCE Model SMK1021ASO WARNING NOTICE TO INSTALLER: READ ALL INSTRUCTIONS BEFORE INSTALLATING AND USING LEAVE THESE INSTRUCTIONS APPLIANCE. FAILURE TO FOLLOW THESE INSTRUCTIONS COULD RESULT IN PROPERTY DAMAGE, BODILY INJURY OR EVEN WITH THE GRILL OWNER DEATH.
Page 2
IMPORTANT SAFETY WARNINGS WE WANT YOU TO ASSEMBLE AND USE YOUR GRILL AS SAFELY AS POSSIBLE. THE PURPOSE OF THIS SAFETY ALERT SYMBOL IS TO ATTRACT YOUR ATTENTION TO POSSIBLE HAZARDS AS YOU ASSEMBLE AND USE YOUR GRILL & SMOKER. WHEN YOU SEE THE SAFETY ALERT SYMBOL, PAY CLOSE ATTENTION TO THE INFORMATION WHICH FOLLOWS! READ ALL SAFETY WARNINGS AND INSTRUCTIONS CAREFULLY BEFORE ASSEMBLING AND OPERATING YOUR GRILL &...
GENERAL WARNINGS: WARNING When using electric appliances, basic safety precautions should always be followed including the following: • Operate only per manufacturers instructions. • Keep all combustible materials at least 60 inches (152.4 cm) away from the grill at all times. Do not use this grill under any overhang or near any combustible structures.
Page 5
• This product is not designed for tabletop use. Do not set this product on a tabletop. • Do not cover cooking grates with aluminum foil. If you cover the heat tents with foil, do not block the openings between heat plates and grill body. •...
USE CAUTION AND COMMON SENSE WHEN OPERATING YOUR PELLET GRILL & SMOKER. FAILURE TO ADHERE TO THE SAFETY WARNINGS AND GUIDELINES IN THIS MANUAL COULD RESULT IN SEVERE BODILY INJURY OR PROPERTY DAMAGE. SAVE THIS MANUAL FOR FUTURE REFERENCE. OPERATING THE GRILL: WARNING Read and follow all warnings and instructions contained in the preceding sections of this manual.
Page 7
Step 2 Make sure temperature control knob is “OFF” . Plug power Control Panel cord into a GFI (grounded) outdoor electrical outlet. When connecting, fi rst connect plug to the outdoor cooking gas appliance then plug appliance into the outlet; Use only a Ground Fault Interrupter (GFI) protected circuit with this outdoor cooking gas appliance;...
Page 8
Follow these steps If the grill does not ignite or if the fi re in the fi re pot goes out while cooking: Step 1 Turn the temperature control knob to “OFF” and unplug. Open cooking chamber lid and remove all food, cooking grates, grease tray and heat baffle plate. CAUTION: Some parts may contain sharp edges.
Page 9
OPERATING TIPS: • Your Pellet Grill should never be moved while it is hot. If you are transporting your grill in a vehicle after cooking on it, make sure the fi re is completely out and the grill is cold before placing it in any vehicle. NEVER put water into the fi re pot.
Page 10
COOK MODE: • The temperature dial can be changed at any time to increase or decrease the cooking temperature of the grill. • The 200°F to 300°F temperature settings are for slow cooking/smoking. • The 325°F to 450°F temperature settings are for grilling. •...
PROPER CARE & MAINTENANCE: • Remove wood pellets from hopper if grill will not be used for a long period of time. Wood pellets can become soggy due to moisture/humidity and can cause the auger to bind up or not push pellets to burn chamber.
TRANSPORTING AND STORAGE: WARNING • Never move a grill when it is hot or when objects are on the cooking surfaces. • Never store fl ammable liquids or spray canisters under or near the grill. • DO NOT extinguish grease fi res using water. BEFORE STORING YOUR GRILL: •...
Temperature 1. Temperature fl uctuations are normal for pellet grills. Any signifi cant fl uctuations can be caused by wind, air temperature, improper use, or lack of grill maintenance. fl uctuations For more information, please visit us at www.cuisinart.com...
WIRING DIAGRAM: THERMOCOUPLE POWER CORD BLACK WHITE DC 12V3A Power Supply and Control POWER SUPPLY Wire FUSE HOLDER 5 Amp Fuse PURPLE WHITE FIRE POT WHITE IGNITOR AUGER MOTOR ORANGE WHITE BLOWER FAN BLUE WHITE GRAY GREEN YELLOW BLACK DISPLAY PANEL POWER SUPPLY Power supply mounted inside AUGER box...
Page 15
IC: 25523-0356 FCC ID: 2AURUJINHENG The device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause any undesired operation.
Page 16
WARRANTY PROOF OF PURCHASE is required to access this warranty program, which is in eff ect from the date of purchase. Customers will be subject to parts, shipping, and handling fees if unable to provide proof of the purchase or after the warranty has expired.