How To Manage: Error Codes - Electrolux CKS980X1 User Manual

Problems with cleaning procedure
Description
The water drawer is difficult to
clean.
There is no water inside the
grill -/ roasting pan after des‐
caling.
There is dirty water on the
bottom of the cavity after des‐
caling.
There is too much water on
the bottom of the cavity after
cleaning.
Cleaning performance is not
satisfactory.
Power cut always stops cleaning. Repeat cleaning if it's interrupted by power failure.

12.2 How to manage: Error codes

When the software error occurs, the display shows error message.
In this section, you will find the list of the problems that you can handle on your own.
Code and description
F111 - Food sensor is not correctly inserted in‐
to the socket.
F240, F439 - the touch fields on the display do
not work properly.
Possible cause
The lid and the wave breaker
were not removed.
The water drawer was not fil‐
led in to the maximum level.
The grill -/ roasting pan is on a
wrong shelf position.
You put too much detergent in
the oven before you started
cleaning.
You started cleaning when the
oven was too hot.
You did not remove all the ac‐
cessories from the oven be‐
fore cleaning.
Fully plug Food sensor into the socket.
Clean the surface of the display. Make sure
there is no dirt on the touch fields.
TROUBLESHOOTING
Remedy
Remove the lid and the wave
breaker.
Check if a descaling agent /
water is present in the water
drawer body.
Remove the remaining water
and the descaling agent from
the bottom of the oven. Next
time put the grill -/ roasting
pan on the first shelf position.
Next time evenly spread the
thin layer of a detergent on
the cavity walls.
Wait until the oven is cold. Re‐
peat cleaning.
Remove all the accessories
from the oven. Repeat clean‐
ing.
Remedy
93/256