Using Setup To Configure The Pc - HP Vectra VE5 3 Supplementary Manual

Using SETUP to Configure the PC

Field Name
Date
Time
User Preferences
Processor
Computer speed
Coprocessor
Memory Size
Memory Cache
Power
Management
Standby
Sleep At
Hard Disk Drives
Drive 1
Drive 2
Interface
SCSI BIOS ROM
Address
SCSI BIOS
Shadowing
VL5/xx & VE5/xx Familiarization Guide
Purpose
To set date and time
Allows you to set:
User Password (Vectra VL)
Password (vectra VE)
Keyclick volume
Character repeat speed
Auto repeat delay
Numlock on/off at power up
Shows the type of
processor in the PC.
Shows the computer speed.
Shows the tpye of
coprocessor in the PC.
State the memory size of:
Base, on system board
Reserved
Extended
Total
Controls level-one and
level-two memory cache.
Enable or disable "Standby"
mode.
Enable or disable the
"Sleep At" power
management feature.
Allows you to configure the
primary and secondary hard
disk drives.
To define if t he integrated
IDE controller is used for
the IDE hard disk drive.
View the SCSIBIOS ROM
address for an HP SCSI
adapter.
To shadow the SCSI BIOS
inf aster RAM for HP SCSI
adapters.
Options
YYYY/MM/DD
HH:MM:SS
Set/Not set
Set/Not set
0 to 10
2 – 30 per second
0.25 – 1 second
On/Off
On/Off
On/Off
On/Off
None or SCSI
Custom
Enabled/Disabled
Enabled/None
Enabled/Disabled
Troubleshooting and Repair
Remarks
Automatically
detected.
Confirm that
SETUP has
detected and
configured the
memory size
fields. Ensure
that the TOTAL
field is correct.
For maximum
performance set
to On.
Shows capacity
of the hard disk
drive if one was
detected.
Configure any
controller board
according to its
manual.
47