Apera 2310T-S User Manual

2310T-S High-Range Conductivity/Temp. Electrode

Brief Introduction

Apera Instruments 2310T-S High-Range Conductivity/Temp. Electrode is featured with a proprietary
platinum black ring sensor for accurate readings in an ultra-wide conductivity range up to 2000 mS/cm,
along with a built-in temperature sensor for automatic temperature compensation.

Technical Specifications

Range
Housing
Constant
Connector
Cable length
Dimension
Temperature sensor
Operating temperature

How to Install the Electrode

1. Find the 8-pin socket on the meter; Open the rubber cap; Insert the connector to the socket with
the notch correctly aligned. Twist on the metal ring to lock the connection.
After connecting the new electrode to your meter, adjust the meter's constant K to 10 according
2.
to the instruction of your meter's manual. Then perform a 2 to 3-point calibration to ensure the
accuracy.

How to Use the Electrode

1. There is a proper amount of deionized water in the cap on top of the electrode. The conductivity
sensor is soaked in it to keep its sensitivity.
User Manual
20 to 2000 mS/cm, 32 to 122°F (0 to
50°C)
POM
K=10
8-pin
3 Ft
ø12*145 mm
30KΩ thermistor
32 to 176°F (0 - 80°C)