HP Rp5000 - Point of Sale System Management Manual page 25

Desktop Management Guide
6. Go to Advanced > PCI Devices to disable both the PATA and
SATA controllers. When disabling the SATA controller, note the
IRQ to which the controller is assigned. You will need to reassign
the IRQ later. Exit setup, confirming the changes.
SATA IRQ: __________
7. Insert a bootable DOS diskette with FDISK.COM and either
SYS.COM or FORMAT.COM into a diskette drive and turn on
the computer to boot to the DOS diskette.
8. Run FDISK and delete any existing partitions on the USB flash
media device. Create a new partition and mark it active. Exit
FDISK by pressing the
9. If the system did not automatically restart when exiting FDISK,
Ctrl Alt Del
press + +
10. At the A:\ prompt, type
will format the USB flash media device, add the system files, and
ask for a Volume Label.
Enter
11. Press for no label or enter one if desired.
12. Turn off the computer and unplug the power cord. Open the
computer and re-install any PCI cards that were previously
removed. Close the computer cover.
13. Plug in the power cord, remove the diskette, and turn on the
computer.
14. As soon as the computer is turned on, press
monitor light turns green to enter Computer Setup. Press
bypass the title screen, if necessary.
15. Go to Advanced > PCI Devices and re-enable the PATA and
SATA controllers that were disabled in step 6. Put the SATA
controller on its original IRQ.
16. Save the changes and exit. The computer will boot to the USB
flash media device as drive C.
www.hp.com
Desktop Management Guide
Esc
key.
to reboot to the DOS diskette.
FORMAT C: /S Enter
and press . Format
F10
when the
Enter
to
21