Dometic Oceanair Skysol Powered Roofblind Installation And Operating Manual page 23

Skysol Powered Roofblind
If packing of tracks is required do not fully tighten the screws before packers
are in place as this can cause damage to the tracks (fig. 3, page 4).
It might be easier to loosely fit the four corner screws (1.) first to position and
hold the blind while the main fixings (3.) are fitted.
If fitting a curved frame then it is better to position the blind vertically using
the side track screws rather than the corner screws.
7.2.2 Connecting the motor
➤ Connect the motor as shown:
– Dometic radio controlled blind internal receiver (fig. 7, page 6)
– Dometic radio controlled blind external receiver (fig. 8, page 6)
– Manually switched blind (fig. 9, page 6)
– Somfy radio controlled blind external receiver (fig. 0, page 7)
– Somfy radio controlled blind internal receiver (fig. a, page 7)
7.3 Frame fitting (flat pack version)
7.3.1 Frame assembly
A
NOTICE! Risk of damage
• When unpacking, leave the blue tape on the side tracks to aid assembly.
• Ensure that the frame is not twisted during installation, as distortion will
damage the blind and effect operation of the blind.
Proceed as follows (fig. 5, page 5):
➤ Assemble the shaft inside the head rail to the sprocket in the side trail, using
the couplings as shown.
➤ Fix the corner brackets to the head rail with the screws provided.
7.3.2 Frame fitting
A
NOTICE! Risk of damage
• Use packing material where required (fig. 3, page 4).
• Use suitable screws and plugs for the wall construction to fix the frame to
the recess. Pre-drill at the marked points.The heads of screws may be no
larger than 6.0 mm in diameter.
• Ensure not to drill through the wall.
• Ensure not to damage the channel in the side tracks.
• Consider using two people to install the product if the blind is large or the
installation location is difficult to reach alone.
• Take care not to leave screws or other debris inside the side tracks as this
can jam the shoes in the tracks.
EN
Installation
23