Low Battery Alarm; System Fault Alarm - Honeywell GA-SP01 User Manual

Low Battery Alarm

Note: Once the Low Battery Alarm has been activated you
have approximately 20 minutes before the sampler turns off.
The sampler tests the batteries on activation and
continuously thereafter. If the battery voltage is low, the
sampler activates the Low Battery Alarm. The audible alarm
will beep once every 20 seconds and the green ON LED will
flash.
The Low Battery Alarm continues until you replace the
batteries or the battery power nears depletion. If the battery
voltage drops too low, the audible alarm beeps once the red
FAIL LED lights and the sampler turns off.
optimumstores
www.
Shop for BW products online at:
See the section Replacing the Batteries.

System Fault Alarm

If the sampler detects a system fault the red FAIL LED will
light and the audible alarm will beep.
Press C to clear the alarm. The sampler will automatically
enter the calibration mode. If the sampler passes calibration
it will enter normal operation mode. If calibration fails see the
section If the Sampler Does Not Work.
.com/bw
The Sampler
Alarms
13