Table of Contents
Advertisement
HOW TO MAINTAIN THE AUTOMATIC ICE MAKER
Ice Maker
● When using for the fi rst time
Cleaning
● When not used for more than one week
Ice tray and water supply line can be washed.
Be sure to check the followings before starting the operation.
● Water supply container
・Water is fi lled in it.
・The container is set properly as
specifi ed.
● Ice case
・If there remains ice, remove it.
Go to the next step after checking them.
Push the 製冰 button and hold it for more
1
than 5 seconds after closing all the doors
and turning on the display.
Release the button when 大顆 / 標準 / 停止
indicator lamps fl ash and the buzzer sounds. Ice
Maker Cleaning will start.
About
5 seconds
・ The indicator lamp will fl ash and the buzzer will sound for about
3 minutes.
・ 製冰機清潔 (Ice Maker Cleaning) can ' t be interrupted.
・ Opening any door of the refrigerator during the Ice Maker
Cleaning may cause malfunction. Do not open/close any door
until Ice Maker Cleaning fi nishes.
・ Alarm will sound even after stopping the Door Alarm.
The buzzer will stop and the indicator lamp will be
2
turned off in about 3 minutes. After that, remove
water in the Ice case and wipe the case.
Make sure that water does not spill
out when removing the case.
There is no problem with using water remaining in the water supply
container, if any.
Ice tray
● Maintain it once a year
製冰
Push the
button to stop supplying water to the ice
1
停止
tray and turn on the
※ If the indicator lamp
fl ashes, perform the
following operation after
the " 停止 " lamp is
turned on in 20 seconds.
Open the Ice Compartment Door.
2
① Pull down the lever and ② draw the frame.
③ Raise the cover ( ▲ part) in the direction of the arrow.
④ Remove the ice tray from the frame.
Cover
Notice
● If you cannot push the frame of the ice tray into the end, the ice tray drive motor may have operated.
Remove the ice tray once and push the frame in, and wait 1 minute after closing the Ice Compartment Door.
Preparation for the ice tray drive motor fi nishes, and you can set the ice tray.
Press this button for
more than 5 seconds
製冰機清潔
（按 5 秒閃爍）
indicator lamp. (Stop ice making)
Light ON
製冰機清潔
Press this button to turn on
（按 5 秒閃爍）
the 停止 indicator lamp.
▲ part
Frame
Water supply container
● Recommended maintenance intervals
Tap water
Mineral water, well water, water purifi ed by water
purifi er, cooled boiled water, etc. (water which doesn't
contain chlorine)
Water which doesn't contain chlorine may easily cause slime and/
or fur compared with tap water. Wash the Water Supply Container
regularly to prevent bacteria from breeding when such water is used.
● Remove the seal from the lid and wash it with a
soft wash sponge.
Water supply
cover
Seal
Water fi lter
Water supply
container
Container-full
line
Add water line
Water fi lter
(Replace it normally every 3 〜 4 years.)
Turn the case and remove it
1
from the lid.
Pull the tab of the water
2
fi lter with fi ngers and
remove it from the case.
Wash it with a soft
3
wash sponge etc.
● Wash the water supply container thoroughly and
Notice
replace it after drying it if you stop ice making and you
are not to use the Automatic ice maker for a while.
● In particular, dry the water fi lter thoroughly.
Empty the ice tray and wash it lightly in the stream.
3
① Set the ice tray and ② close the cover.
4
③ Make the frame horizontal and push
it into the end, and
④ Pull up the lever.
Lever
製冰
Push the
(Automatic Ice Making
starts)
Once a week
Once three
days
● How to open the lid
Lid
Case
● How to close the lid
(Front)
Insert the lid from its rear side and
close it in the direction of the arrow.
Pg.57
Do not use the
detergents etc.
Do not use any cleaning
tool that can scratch it easily
such as scrubbing brush and
plate powder.
Click
Is the lever in
horizontal state?
button to turn on the indicator lamp.
製冰機清潔
（按 5 秒閃爍）
Push this button to turn
Light ON
on the indicator lamp
(Back)
Tab
Lever
Horizontal
51
Advertisement
Table of Contents
