Table of Contents
Advertisement
TROUBLESHOOTING
When this happens
It smells strange
Ice smells
It smells in the
refrigerator
It smells like
plastic
Door is not in a horizontal state
Door is not in a
horizontal state
More force is required to
open the door immediately
after closing the door.
Another door opens
after closing one door.
Others
You feel electricity a little
when touching the main
body of the refrigerator
Radio and/or
television are
disturbed by noises
There are thin lines
like scratches on the
plastic parts
There are waving and/or distortions
on the door surface, the side and the
top surface of the refrigerator.
The Control Panel for
operation is not illuminated
There is a small hole
inside the door
56
● Do the water supply container and/or water fi lter become dirty? or Does ice become old?
→ Wash them once a week to prevent "slime" and/or "fur".
● Chlorine may strongly smell because chlorine in tap water is condensed.
● Is any food which strongly smells stored without any wrapping?
→ The deodorizing function cannot completely remove all smells.
Seal that kind of food with plastic fi lm etc. to store it.
● This smell occurs because a lot of plastic parts are used in the refrigerator, but the smell
decreases gradually while cooling. Keep the room ventilated.
● Installation place may not be horizontal.
Left side or right side of the door may be slightly lower when the left or right leg is sunk in the
fl oor surface because of the soft fl oor material and the addition of food weight.
→ This does not affect the refrigerator performance. Adjust the refrigerator adjustable mount to keep
it level if you want to correct it.
→ Lay the fi rm board which has more than 1cm thickness on the fl oor if the refrigerator itself
inclines.
● It is because air entered the Refrigerator Compartment is rapidly cooled and the pressure in the
Refrigerator Compartment temporarily lowers.
● Another door may open for a moment by the wind pressure because cool air path connects each
compartment.
● The refrigerator may be charged with static electricity, but there is no problem with the safety.
→ It is recommended to ground if you want to remove it.
● It is caused by the electromagnetic radiation slightly generated from this refrigerator.
→ Install the refrigerator on a place far away from the television, radio and interphone etc.
→ It is recommended to connect the power plug to the power outlet separated from the antenna
terminal and ground the refrigerator.
● Those lines are caused by the liquid resin fl owing when plastic is molded.
They are especially conspicuous for the transparent parts, but there is no problem with the
strength and they can never lead to any cracks.
● Slight waving and/or distortions are generated in the manufacturing process of the refrigerator.
They may be conspicuous according to the position of the light source and/or the brightness etc.,
but there is no problem with the performance.
● The displayed character will disappear about 2 minutes after the operation fi nishes. However, 急
冷 (Quick Cooling) or eco operation indicator lamp will not be turned off. Push either button to
turn it on.
● This hole is used to escape the air inside when fi lling the heat insulation
material into the door during the production process. It is neither a fl aw nor
abnormal thing.
Please check. This is the cause.
Pg.34
Pg.37
Pg.51
Pg.37
Hole (inside of the door)
Advertisement
Table of Contents
