How To Maintain The Automatic Ice Maker; When Using For The Fi Rst Time / When Not Used For More Than One Week - Hitachi R-S42CMJ How To Use Manual

HOW TO MAINTAIN THE AUTOMATIC ICE MAKER

Water supply
container
Ice tray
Ice Compartment
When using for the fi rst time / When not used for more than one week
Washing the supply channel (Ice Maker Cleaning)
Ice tray and water supply line can be washed.
Be sure to check the followings before starting the operation.
Go to the next step after checking them.
Lay a soft clean towel on the bottom of the ice case.
1
This is to suck water drained from Ice Maker Cleaning,
preventing it from spilling out of a cutout located behind in
the Ice Maker case.
Push the
2
after closing all the doors and turning on the display.
When the three indicator lamps "
" ( Ice Making)" and "停止 ( Stop)" start to blink and alarm
starts to sound, stop holding the button. "
Cleaning)" starts.
・ The indicator lamp will fl ash and the buzzer will sound for about 3
minutes.
・ "
・ If you open any of the refrigerator doors during Ice Maker
Cleaning, the cleaning may not work properly. Do not open or
close the door until cleaning is completed.
・Door alarm sounds even if alarm is disabled.
About three minutes later, when alarm and blinking
3
end, remove water in the ice case using the towel.
There is no problem with using water remaining in
the water supply container, if any.
50
● Water supply container
・Water is fi lled in it.
・The container is set properly
as specifi ed.
button and hold it for more than 5 seconds
( Quick Ice Making)" ,
(Ice Maker Cleaning)" can ' t be interrupted.
(Ice Maker
Pg.57
Before removing
the case, wipe
off the water in
the case.
Warning
■ Do not put your hand in the
mechanical part of the Automatic
ice maker.
You may be injured when the Ice tray
turns.
● Ice case
・If there remains ice,
remove it.
To prevent malfunction, lay the
towel so that its thickness does
not reach this line.
Press this button for
more than 5 seconds
About
5 seconds