Lambrecht Ser[LOG] Operator's Manual page 11

The configuration of the Ser[LOG] takes place with the "Ser[Log] Commander". This application has a
sensor library from which the channels of the Ser[LOG] can be easily and quickly assigned by "point
and click" with sensors from the LAMBRECHT product range. In addition, users can add their own sen-
sors and thus extend the sensor library.
Virtual channels like dewpoint calculation or reduction of air pressure can be defined from the existing
formula collection or by the formula interpreter.
Regardless of the configuration and the storage interval, the Ser[LOG] stores all measurement values
in a ring buffer, which holds data for exactly 1 year. After that, the oldest value is overwritten.
With the MeteoWare CS4 the data collected can be conveniently analyzed. (The MeteoWare CS 4 is
not included!)
The communication of the Ser[LOG] with the user's PC is either via
•
cable connection (RS232, RS422, RS485)
•
network connection (100 Mbps Ethernet) or
•
wireless or mobile (GPRS, EDGE, UMTS, HSPA +, LTE)
• USB and Bluetooth (only for service purposes)
A total of 26 simultaneous communications are supported.
In the "push mode" the Ser[LOG] automatically sends the measured data via FTP and / or e-mail Ether-
net, WiFi or cellular (2G / 3G / 4G).
The Ser[LOG] can control up to 10 "Switching Channels", each switch a relay and / or send e-mail or
SMS messages. The Ser[LOG] provides two built-relays; additionally up to 8 external Modbus relays
can be controlled.
LAMBRECHT meteo GmbH Ser[LOG] Manual Page 11 of 129