Table of Contents
Advertisement
BLADE RAISING AND
TILTING HANDWHEELS
1. Assemble the blade raising handwheel (A) Fig. 7, to
the blade raising shaft (B). Make sure the slots (C) in the
hub of the handwheel are engaged with the roll pin (D)
on the shaft.
2. Place a flat washer onto the end of the raising shaft.
Thread the lock knob (E) Fig. 8, onto the shaft.
3. Assemble the blade tilting handwheel (F) Fig. 8, to
the blade tilting shaft in the same manner.
4. Thread the lock knob (G) Fig. 8, onto the blade tilting
shaft.
EXTENSION WINGS
1. Align the three holes in the extension wing (A) Fig. 9,
with the three holes in the side of the saw table. NOTE:
DO NOT TIGHTEN HARDWARE AT THIS TIME. Place
a 5/16" lockwasher and a 3/8" flat washer onto a
M8x1.25x16mm hex head screw. Insert the screw
through the hole in the extension wing and thread the
screw into the tapped hole in the side of the saw table.
Repeat this process for the two remaining holes in the
extension wing and the saw table.
2. With a straight edge (C) Fig. 10, make certain the
extension wing (A) is level with the saw table before
tightening three screws (B) Fig. 9.
3. Assemble the other extension wing to the opposite
side of the table in the same manner.
A
B
C
10
B
D
C
Fig. 7
F
E
Fig. 8
A
B
Fig. 9
A
Fig. 10
G
Advertisement
Table of Contents
