Step 4: Extension Wings - Delta 36-725 T2 Quick Assembly Manual

Step 4: EXTENSION
WINGS
Hardware Bag "C,D"
1.
Attach the Extension Wings
x 7/8 Hex Screw with Split Lock Washers
Wing. The Wings attach from underneath as shown in Figure
10. Be sure to use a Level or Combination Square to keep the
Extension Wings level with the Table. NOTE: Hole patterns on
the two long edges of the extensions are different. See Figure
10A.
2.
Attach the Extension Wings to the Front and Rear rails using
(8) 5/16-18 x 1-1/8 inch Flat Countersunk Hex Screw
5/16-18 Hex Flange Nuts
11. Be sure to confirm the Front and Rear Rails are level with
the Extension Wings by using the Rail Alignment Gauge
See Figure 5-9.
3.
Repeat this process on Front and Rear Rails for both Extension
Wings.
4.
Attach the Spreader Bar
and Rear Rails using (4) M8 x 16 Hex Shoulder Screws
and (4) M8 Nylock Nuts
to the Table using (6) 5/16-18
PC10
, (3) for each
HP7
, (4) for each wing. See Figure
HP13
to the outboard end of the Front
PC17
. See Figure 12.
HP9
and
HP15
.
HP20
HP8
HP7
UNDERSIDE OF WING UNDERSIDE OF WING
Figure 10
EXTENSION EXTENSION
WING WING
PC10
Figure 11
HP9
PC17
HP8
Figure 12
Figure 10A
HP13
HP15