Fitting And Removal Of Base : Prolite E2283Hs - Iiyama ProLite E2283HS User Manual

FITTING AND REMOVAL OF BASE : ProLite E2283HS

 Put the monitor on a stable surface. The monitor may cause injury or damage if it
CAUTION
falls or is dropped.
 Do not give a strong impact to the monitor. It may cause damage.
 Unplug the monitor before removal or installation to avoid an electric shock or a
damage.
<Installation>
Put a piece of soft cloth on the table beforehand to
prevent the monitor from being scratched. Lay the
monitor flat on a table with front face down.
Hold the monitor and install the Stand-Neck to the
monitor until it clicks to secure.
Hold the monitor and install the Stand-Base to the
stand-neck until it clicks to secure.
Place the Cable Holder.*
NOTE
* The cable holder cannot be removed after installation.
<Removal>
Put a piece of soft cloth on the table beforehand to
prevent the monitor from being scratched. Lay the
monitor flat on a table with front face down.
Keep pressing the hooks inward to pull out the Stand-
Base.
Press the hook on the back of the monitor and remove
the Stand-Neck from the monitor.
8 BEFORE YOU OPERATE THE MONITOR
Cable Holder
Hook
Stand-Neck
Stand-Base
Hooks