Eaton 9E10000i Manual page 17

Table 4-3 Buzzer
Priority UPS condition
1 UPS fault and failure
2 Normal mode
Battery/battery test mode
3
4 Bypass mode
5 Overload
6 Other alarm
7 Manual bypass
Note: buzzer alarm can be enable/disable by function button, if buzzer alarm is disabled, all present alarm is muted
except that the button press still has a tick beep. Buzzer alarm will be enabled automatically once new alarm arises.
Interface
In order to make sure all segments are OK, LCD begins to do self-test after power on. During self-test, all the segments
will be lighted for 2 seconds, then the LCD will turn to normal display status.
Buzzer
Continuous
No beep
One beep per 4 sec
(One beep per 1s when battery low)
One beep per 2 minutes
One beep per 500ms
One beep per 1s
One beep per 1s
Fig. 4-2 The default LCD display
Icon Icon name
Measurements
DC Voltage
Percentage
Output
Input
Load
Battery
Load level
Battery level
Warning/Fault
Description
Display values, eg: voltage, frequency,
load percentage, etc.
Battery voltage
The percentage, eg: Load percentage and
battery capacity percentage
It indicates information for output.
It indicates information for input.
It indicates information for load.
It indicates information for battery.
It indicates the load level. Load border will
flash if the load is overload.
It indicates the battery capacity. Battery
border will flash if the battery is low.
It indicates warnings or UPS Fault .
If it is a warning, the icon will flash; if it is a
fault, the icon will be lighted constantly.
Page 17