Advertisement
Quick Links
Model: T-2300A
WORKING LOAD LIMIT 680 KG
UTILITY/ATV LIFT
OWNER'S MANUAL
WARNING
To avoid crushing and related injuries:
NEVER work on, under or around a load supported only
by a jack. Ensure locking devices are fully engaged.
Imported by
SHINN FU AUSTRALIA PTY. LTD.
15 Viewtech Place, Rowville 3178 VIC Australia
1
Advertisement
Related Manuals for Pro-Lift T-2300A
Summary of Contents for Pro-Lift T-2300A
- Page 1 Model: T-2300A WORKING LOAD LIMIT 680 KG UTILITY/ATV LIFT OWNER’S MANUAL WARNING To avoid crushing and related injuries: NEVER work on, under or around a load supported only by a jack. Ensure locking devices are fully engaged. Imported by SHINN FU AUSTRALIA PTY. LTD.
-
Page 2: Intended Use
SAVE THESE INSTRUCTIONS For your safety please read, understand and follow the information contained within before use. The owner and operator shall have an understanding of this product and safe operating procedures before attempting to use. Instructions and safety information shall be conveyed in the operators native language before use is authorized. Make certain that the operator thoroughly understands the inherent dangers associated with the use and misuse of the product. -
Page 3: Parts List
PARTS LIST ITEM PART NO. DESCRIPTION T-2300A-1 Front Wheel Assy T-2300A-2 Rear Wheel Assy T-2300A-3 Hydraulic Unit Assy T-2300A-4 Height Lock Release T-2300A-5 T-handle T-2300A-6 Hardware Kit (Not Shown) - Page 4 ASSEMBLY INSTRUCTIONS 1. Install Hydraulic Ram Attach hydraulic ram to the ram platform with bolts (21) and washers (22) (24). Bolt (21) Lock washer (22) Washer (24) Hydraulic ram Ram platform 2. Attach Hydraulic Ram & Lock Bar A. Remove cotter pin and lock pin (27) from ram. Raise load frame (19) by hand and align the head of the hydraulic ram with the tab holes in the low center of the load frame.
- Page 5 ASSEMBLY INSTRUCTIONS 3. Install Pump Pedal. Pump pedal (29) Hydraulic ram Bolt M8x12 (32) 4. Install Handle. T-handle (25) Load frame (19) Handle pin (20) INSPECT BEFORE EACH USE Do not use if cracked, broken, bent or otherwise damaged parts are noted or if the lift is suspected to have been subjected to a shock load.
- Page 6 OPERATING INSTRUCTIONS 1. Position Lift under appropriate lift point, centering load on lift platform. 2. Locate and pump the lift pedal until the lift platform comes into contact with an appropriate lift point. 3. After centering the load, slowly and carefully raise the lift platform by pumping the lift foot pedal. 4.
-
Page 7: Care And Maintenance
Hydraulic unit bleeds off after lift • Overload condition • Remedy overload condition contact • Hydraulic unit malfunction PRO-LIFT Customer Support • Ensure Load is removed, then • Reservoir overfilled Lift will not lower after unloading • Drain fluid to proper level •...