Table of Contents
Advertisement
HOW TO R E CHARG E THE
In a ventilated area, insert the charger connector into the corresponding
battery charging connector, then
the charger into a standard current plug a 230V ~ 50Hz.
Do not recharge the battery in closed and poorly ventilated places!
Verify that the charger connector and plug are not damaged.
During charging, the charger indicator is red; when the battery is full, the
indicator turns green. The time needed for a full charge is approximately
6 hours. This may vary considering the residual charge.
The
supplied
Green
light:
tion
(battery
Red
light:
Light off: charger in standby (energy saving mode activated).
This last mode is activated after about 30 seconds / one mi-
nute
after
the
charger
To return to normal operation, disconnect the charger from the mains for
about one minute (reset the standby function) and reconnect it to carry
out a new charging operation.
After charging is completed, pull out the charger plug from the socket,
then disconnect the charger connector from the bicycle charging hole.
Do not leave the charger connected to the socket for a long time after
charging has been completed.
If a smell comes out from the charger during charging, the temperature
may have become too high; please stop charging immediately and send
the unit for maintenance.
Use only the charger supplied with the bicycle to avoid damage to the
battery and not to void the warranty.
lithium battery, do not replace with incorrect bat-
16
BATT ERY
chargers
end
charged)
charging
the
charging
activated
WARN ING
tery type, danger of explosion.
have
3
of
or
no
operation
operation
without
any
operating
recharging
battery
connected.
in
is
finished
battery
connected.
modes:
opera-
progress
or
with
Advertisement
Table of Contents
