Programming Of The Usb Controller Firmware; Installation Usb_Updatetool - Feig Electronic OBID i-scan ID ISC.PR101 Application Note

®
OBID i-scan Application-Note ID ISC.PR/MR101-USB

1. Programming of the USB Controller Firmware

With the update of the USB-Controller it is possible to use the USB-Reader ID ISC.PR/MR101 in
the scan mode. This is only necessary if you have one of the first USB-Reader ID ISC.PR/MR101
and the san mode is not available.
After that it is necessary to install the new reader firmware version 1.01 or higher. This can be
done with the "OBIDFirmwareUpdateTool" via the USB-Interface. This is described in the Applica-
tion Note „N30300-0e-ID-B.pdf".

1.1. Installation USB_UpdateTool

Unzip the „USB_UpdateTool_PR_MR101.zip" with the option „use path specification"
After that you will get the following tree:
FEIG ELECTRONIC GmbH Page 5 of 8 N50402-0e-ID-B.doc