Table of Contents
Advertisement
WARNING!
Deactivate the appliance before carrying out any check.
In case of major problems, the acoustic signals operate, the display shows an
error code and the Start/Pause button may flash continuously:
Error code
Appliance motor overloaded.
Too much laundry or entrap in
E5A
the drum.
Internal fail. No communication
between electronic elements of
the appliance.
E97
The mains supply is unstable.
EH0
If the display shows other error codes, deactivate and activate the appliance. If the
problem continues, contact the Authorised Service Centre.
In case of different problem with the tumble dryer check the table below for possible
solutions.
14.2 Troubleshooting
Problem
You cannot activate the appliance.
The program does not start.
The appliance door does not close.
Possible cause
Possible solution
Make sure that the mains plug is connec‐
ted to the mains socket.
Check fuse in fuse box (domestic installa‐
tion).
Press Start/Pause.
Make sure that the appliance door is
closed.
Make sure that the installation of the filter
is correct.
Make sure that the laundry is not caught
between the appliance door and the rub‐
ber seal.
Remedy
The program was not completed.
Remove the laundry from the
drum, set the program and re‐
start the cycle.
The program was not finished
properly or the appliance stoped
too early. Switch the appliance
off and on again.
If the error code appears again,
contact the Authorised Service
Centre.
When the appliance is showing
EH0, please wait until main sup‐
ply is stable than press start. If
the appliance pause the cycle
without any indication then press
the cycle start. If the warning will
occur check the power cord /
socket integrity or main supply.
ENGLISH
23
Hide quick links:
Advertisement
Table of Contents
