Advertisement
3
Installing a Cabinet
Secured Installation
1. Determine the position for installing the
cabinet. Mark mounting holes based on the
drawings (unit: mm).
2. Use a hammer drill to drill four holes for
installing expansion bolts and then install
four expansion bolts in the holes. Remove
the bolt, spring washer, and flat washer.
Non-Secured Installation
1. Lower the four leveling feet at the
bottom of the cabinet by using a
wrench until all the four castors at the
bottom hang in the air and the leveling
feet bear the whole cabinet weight.
2. Check whether the bottom of the
cabinet is horizontal by using a level
instrument. If the cabinet is not leveled,
adjust the leveling feet.
3. Slide the cabinet on its castors to the
installation position.
4. (Optional) If the castors of the SmartLi need
to be lifted from the ground, perform Step 1
to Step 2 in Non-Secured Installation.
5. Open the front door, and remove the four
rubber plugs from the bottom of the cabinet.
6. Insert four M12x115 expansion bolts into
the expansion bolt holes in the floor, and
tighten the expansion bolts.
4
Advertisement
