Clearing The Cmos - HP Kayak xu700 Troubleshooting Manual

Clearing the CMOS

1 Turn off the PC Workstation, disconnect the power cord and data
cables, then remove the cover.
2 Set the system board switch
memory.
3 Replace the cover, and only reconnect the power cord.
4 Reboot the PC Workstation. A message similar to the following will
be displayed:
"Configuration has been cleared, set switch Clear to
the ON position before rebooting."
5 Turn off the PC Workstation, disconnect the power cord, and remove
the cover.
6 Set the system board switch
configuration.
7 Replace the cover, and reconnect the power cord and data cables.
8 Switch on the PC Workstation. Run the Setup program by pressing
. Then press
F2 F9
downloaded and saved.
9 Press to save the configuration and exit from the Setup
Esc
program.
8 to the ON
8 to the OFF
, the CMOS default values will be automatically
2 Use or Configuration Problems
Troubleshooting BIOS Problems
position to clear the CMOS
position to retain the
35