Scsi Interface - HP Kayak XA Technical Reference Manual

10BT/100TX PCI LAN
Connector
Ultra wide (16-bit) SCSI
connector
The LAN adapter supports the following two standards: 100 VG-AnyLAN,
100 Mbits per second over 4-pair, category-3, unshielded twisted pair
(UTP), voice grade (VG) cable (IEEE 802.12 standard for Ethernet);
10 BaseT, 10 Mbits per second, ISO 8802-3 (IEEE 802.3 standard). On the
rear panel there is one RJ-45 unshielded-twisted-pair (UTP) connector. The
10BT/100TX LAN Features on
PCI LAN controller.

SCSI Interface

The Symbios Logic SYM5C875J PCI-SCSI I/O Processor chip connects
directly the SCSI bus and generates timing and protocol in compliance with
the SCSI standard.
The SCSI interface operates as 16-bit, synchronous or asynchronous, single-
ended, and supports Ultra SCSI protocols and 16-bit arbitration. The
interface is made through two (and only two) of the connectors J2, J3 and
J4.
Connector
J2 Shielded 68-pin high density right-angle receptacle.
J3 68-pin high density right-angle receptacle.
J4 External Start, SCSI Led and External SCSI cable
detection.
The Ultra wide 16-bit SCSI connector is for internal devices and has an
address range from 0 to 15, with the SCSI address 0 used by the first SCSI
hard disk drive and SCSI address 7 reserved for the integrated SCSI
controller (the default for wide and narrow SCSI devices).
Data is transferred at 40 MB per second on 16-bit wide, single-ended bus.
The controller is fitted with a 16-bit SCSI flat cable with five connectors,
plus a SCSI termination device; so a maximum of 4 internal wide-SCSI hard
drives are supported.
3 Interface Devices and Mass-Storage Drives
page 62 are also valid for the 10 BT/100 TX
Description
SCSI / LAN Combo Board
Location
Protrudes through the
rear panel bracket.
Internal connector at the
end of the board.
Internal connector at the
bottom right-hand-side of
the Combo card.
59