Removing The Power Supply; Figure 3-29. Removing The Speaker - Compaq Deskpro Workstation AP250 Maintenance And Service Manual

3-34 Compaq Deskpro Workstation AP250 Maintenance and Service Guide

Removing the Power Supply

Writer: Bruce Sullivan Project: Compaq Deskpro Workstation AP250 Maintenance and Service Guide Comments:
Part Number: 118133-001 File Name: d-ch3 Removal and Replacement Procedures.doc Last Saved On: 10/26/99 3:02 PM
4. Remove the four screws that secure the speaker to the side of the
chassis 1, then remove the speaker 2.
1

Figure 3-29. Removing the speaker

To reinstall the speaker, reverse the above procedure.
To remove the power supply:
1. Perform the steps in the "Service Preparations" section.
CAUTION: Before removing the side access panel, ensure that the workstation
is turned off, all cables are disconnected from the back of the workstation, and
the power cord is disconnected from the grounded AC outlet.
2. Remove the side access panel.
3. Disconnect all power cables from the mass storage devices and the
system board.
Compaq Confidential – Need to Know Required
2