The Upgrade Process - HP Compaq t1000 Supplementary Manual

Table 28-1 Change DHCP Option IDs Dialog Box, Continued
Function
SNMP Option IDs
Terminal Emulation
Option IDs
Virtual Port Option
IDs
Reset To Defaults

The Upgrade Process

1. Press the F2 key for the Terminal Properties dialog box.
2. Click on the Network tab.
3. Click on the Obtain an IP Address from DHCP Server radio button, if the
function is not enabled.
4. Click on the Apps tab.
5. Click on the DHCP Automatic Update Enable check box on the Apps
properties sheet, if the function is not enabled.
Note
You have now enabled the automatic DHCP function.
You will also need to configure your DHCP option IDs.
Description
Group box used to set the following SNMP option IDs:
• Trap Server IP List
• Set Community
Group box used to set the following terminal emulation
option IDs:
• Emulation Mode
• Terminal ID
Group box used to set the following virtual port option
IDs:
Server
Click on this command button to reset all option IDs to
the default values.
Note
The values shown in Figure 28-1 are the
terminal default values.
161