Cleaning - LFA VM Lab Mixer User Manual

Cleaning

During the VM Lab Mixer's operation, excess powder will find its way into parts of the machine. It
®
is important to clean the VM
LFA recommends that the machine be cleaned after each operation.
Tools and Materials Needed
• Set of metric Allen keys with ball ends
• Crosshead screwdriver
• Cleaning brush
• Bagless vacuum
• Toothbrush
• Cleaner (e.g. Member's Mark Commercial Lemon Fresh Disinfectant)
• Sanitizer (e.g. Member's Mark Commercial Sanitizer) or 70%+ alcohol
• Disposable latex/rubber gloves
• Bowl of warm soapy water (nothing abrasive)
• 3 clean cloths
• Potable water
• Hairnet and/or beard net (food grade products only)
• Sterile shoe covers (food grade products only)
WARNING: To prevent any potential personal injury, ALWAYS unplug the VM
Lab Mixer from the electrical outlet when cleaning the machine.
Instructions
Note: Wear latex/rubber gloves (and appropriate food grade attire if applicable) during this
process.
Remove Parts
1. Remove the Hopper from the machine.
2. Remove the panels.
3. Use a brush to bring powder debris out from hard to reach places.
4. Vacuum the top section of the VM
5. Vacuum the entire areas inside the steel side panel door encasement.
5.1 Note: Be sure to thoroughly vacuum inside the VM
28
Lab Mixer thoroughly to prevent rusting and cross contamination.
®
Lab Mixer base.
®
Lab Mixer's base.
®
®