LFA VM Lab Mixer User Manual page 24

Input Gaskets and Output Gasket
The Input Gaskets are located on top of both sides of the Hopper. The Output Gasket is located in
the discharge chute's opening. The inlet/outlet lids and locking rings must be removed in order to
access the Input Gaskets.
Tools and Materials Needed
• New Input Gaskets/Output Gasket
• Disposable latex/rubber gloves (for food grade products and to protect hands from grease)
• Hairnet and/or beard net (food grade products only)
• Sterile shoe covers (food grade products only)
WARNING: To prevent any potential personal injury, ALWAYS unplug the VM
Lab Mixer from the electrical outlet when replacing parts.
Instructions
Note: Wear latex/rubber gloves (and appropriate food grade attire if applicable) during this process.
Remove the Gaskets
1. Loosen the clamp thumbscrews from the inlets/outlet.
2. Remove the Input Gaskets/Output Gasket from the Hopper's inlets/outlet.
Replace the Gaskets
3. Insert the new Gaskets into the Hopper inlets/outlet.
4. Reinsert the Hopper lids and tighten the clamp thumbscrews.
24
®