Installing Thin Client Options - HP Compaq t5125 Hardware Reference Manual

Hardware Upgrades

Installing Thin Client Options

2-4
3. Remove the chassis cover by removing the two screws 1 and
pulling the chassis cover 2 off.
4. Disconnect the speaker cable 3 from the system board.
Removing the Chassis Cover and Disconnecting the Speaker
To replace the cover, reverse the previous steps.
There are several options available for installation on the thin client
such as flash memory, SODIMMs, and security hardware (see
Appendix B, "Security Provisions"
information). Not all thin clients support the same options. Visit the
http://h18004.www1.hp.com/products/thinclients/
HP website at
options/index.html
to see what options are supported and to order
available options.
The following sections contain general installation instructions for
some of the available options. In all cases, see the specific installation
instructions that came with the thin client option.
Before beginning the installation process, review the "General
Hardware Installation Sequence" section earlier in this chapter, for
instructions on what to do before and after installing any options.
www.hp.com
for security hardware
Hardware Reference Guide