Sodimm Upgrade - HP Compaq t5125 Hardware Reference Manual

Hardware Upgrades

SODIMM Upgrade

Ä
✎
2-6
6. Restore power to the thin client and turn it on.
7. Install the thin client firmware. For installation instructions, refer
to the Troubleshooting Guide or the HP Compaq Thin Client
Imaging Tool white paper available on the HP website at
www.hp.com/products/thinclientsoftware
If the thin client can be upgraded with an optional SODIMM module,
use the following instructions as an overview of this procedure.
CAUTION: If necessary, back up any data before continuing the
installation.
In addition to following these instructions, follow the instructions that
are applicable to the specific thin client option.
1. Complete steps 1 through 4 of the
Sequence" on page
2. Remove any existing SODIMM if one is installed.
3. Install the module into the socket at a 45° angle 1 until it clicks,
then rotate the module 2 into position as shown.
Installing an Optional SODIMM
4. Complete steps 6 through 10 of the
Installation Sequence" on page
www.hp.com
.
"General Hardware Installation
2-1.
"General Hardware
2-1.
Hardware Reference Guide