Table of Contents
Advertisement
36
Hot Key Power On
Onboard FDC Controller
Onboard Serial Port 1/
Onboard Serial Port 2
UART Mode Select
RxD, TxD Active
IR Transmission Delay
Onboard Parallel Port
Parallel Port Mode
If you select ÒHot KeyÓ from the item
above, you will have to choose a key
combination that will wake up the
system here. Choose from Ctrl-F1 to
Ctrl-F12.
Enabled Ð Use the on-board floppy
controller (default).
Disabled Ð Turn off the on-board floppy
controller.
Choose serial port 1 & 2Õs I/O address.
Do no set port 1 & 2 to the same value
except for Disabled. Choose Auto for
automatic setting for the I/O address and
IRQ.
COM1/3F8H
COM2/2F8H
(default)
Choose Normal (default), IrDA 1.0, or
ASKIR to meet the specification of your
Infra Red device.
Choose Hi, Hi; Hi, Lo (default); Lo, Hi;
or Lo, Lo. Ask your IR provider when
you use this function.
Choose Enabled or Disabled. Ask your
IR provider when you use this function.
Choose the parallel port I/O address:
378H/IRQ7 (default), 3BCH/IRQ7,
278H/IRQ5, or Disabled to disable this
port.
Choose ECP+EPP (default), SPP, EPP,
or ECP. The mode depends on your
external device that connects to this port.
BIOS Setup
COM3/3E8H
COM4/2E8H
Advertisement
Table of Contents
