Table of Contents
Advertisement
26
SDRAM RAS-to-CAS
Delay
SDRAM RAS Precharge
Time
SDRAM CAS Latency
Time
CPU Speed
CPU Ratio
CPU Host Clock Select
Spread Spectrum
Use the default setting.
Use the default setting.
Use the default setting.
Select the frequency of your Pentium II
CPU from the following: 133, 233, 266,
300, 333 MHz, or Manual.
133MHz: default setting which allows the
board to boot up at any time if
a wrong CPU frequency setting
crashes the system.
<Insert> during boot-up to load
the BIOS default values.
Manual:
User can select the frequency
and multiplier values if so
desired.
guarantee proper functioning of
the system if the user selects
ÒManualÓ setting, however,
since some combinations fall
outside
specifications.
table on the next page for CPU
freuqency settings.
If you choose ÒManualÓ in the CPU Speed
item above, then you can choose the
multiplier here. The multiplier can be
chosen from a range of 2.0 to 5.5.
If you choose ÒManualÓ in the CPU Speed
item above, then you can set your CPUÕs
Host Clock Frequency here. The choices
for 66MHz Host Clock CPUs are: 50, 60,
66, 68, and 75MHz.
Enabled it when you want to run the FCC
or DOC testing.
BIOS Setup
Press
SOYO does not
of
the
INTEL
Refer to the
Advertisement
Table of Contents
